APPENDIX
|
Table of Contents
|
Appendix Contents
Section 1 Introduction
Section 2 Stress Analysis
Section 3 Deflection Analysis
Section 4 Statistical Considerations in Design
Section 5 The Strength of Mechanical Elements
Appendix Tables
Table A-1 Standard SI Prefixes
Table A-2 Conversion of English to SI Units
Table A-3 Conversion of SI to English Units
Table A-4 Preferred SI Units for Bending and Torsion Stress
Table A-5 Preferred SI Units for Axial Stress and Direct Shear Stress
Table A-6 Preferred SI Units for Deflection of Beams
Table A-7 Physical Constants of Materials
Table A-8 Properties of Structural Shapes - Equal Angles
Table A-9 Properties of Structural Shapes - Unequal Angles
Table A-10 Properties of Round Tubing
Table A-11 Properties of Structural Shapes - Channels
Table A-12 Shear, Moment, and Deflection of Beams
Table A-13 Ordinates of the Standard Normal Distribution
Table A-14 Areas Under the Standard Normal Distribution Curve
Table A-15 Limits and Fits for Cylindrical Parts
Table A-16 American Standard Pipe
Table A-17 Mechanical Properties of Steels
Table A-18 Mechanical Properties of Wrought Aluminum Alloys
Table A-19 Mechanical Properties of Aluminum Alloy Castings
Table A-20 Typical Properties of Grey Cast Iron
Table A-21 Typical Properties of Some Copper-Base Alloys
Table A-22 Typical Mechanical Properties of Wrought Stainless Steels
Table A-23 Typical Properties of Magnesium Alloys
Table A-24 Decimal Equivalents of Wire and Sheet Metal Gauges
Table A-25 Charts of Theoretical Stress-Concentration Factors, Kt
Table A-26 Dimensions of Round-Head Machine Screws
Table A-27 Dimensions of Hexagon-Head Machine Screws
Table A-28 Dimensions of Finished Hexagon Bolts
Table A-29 Dimensions of Finished Hexagon and Hexagon Jam Nuts
Table A-30 Properties of Sections
Table A-31 Mass and Mass Moments of Inertia of Geometric Shapes
Index
GREEK ALPHABET
Mechanical Engineering Design
Appendix Section
©1995
AnalysisChamp.com
12/14/95, 6/18/2010 Comments to
MikeVV@AnalysisChamp.com
